Browsing Upper Sorbian translation

Don't show this notice anymore
Before translating, be sure to go through Ubuntu Translators instructions.
110 of 14 results
1.
Keyboard Repeat
i18n: file: kcmmiscwidget.ui:59
i18n: ectx: property (title), widget (QGroupBox, keyboardRepeatGroupBox)
Wospjetowanje tastow
Translated by Eduard Werner
Located in rc.cpp:147
2.
If you check this option, pressing and holding down a key emits the same character over and over again. For example, pressing and holding down the Tab key will have the same effect as that of pressing that key several times in succession: Tab characters continue to be emitted until you release the key.
i18n: file: kcmmiscwidget.ui:59
i18n: ectx: property (whatsThis), widget (QCheckBox, repeatBox)
Hdyž tutu opciju wubjerjeće, wusyła stłóčena tasta zaso a zaso tón samsny pismik, doniž tastu njepušćiće.
Translated by Eduard Werner
Located in rc.cpp:136 rc.cpp:308
3.
&Enable keyboard repeat
i18n: file: kcmmiscwidget.ui:62
i18n: ectx: property (text), widget (QCheckBox, repeatBox)
&Wospjetowanje tastow zaswěćic
Translated by Eduard Werner
Located in rc.cpp:139 rc.cpp:311
4.
&Delay:
i18n: file: kcmmiscwidget.ui:123
i18n: ectx: property (text), widget (QLabel, lblDelay)
&Přestawka:
Translated by Eduard Werner
Located in rc.cpp:159
5.
If supported, this option allows you to set the delay after which a pressed key will start generating keycodes. The 'Repeat rate' option controls the frequency of these keycodes.
i18n: file: kcmmiscwidget.ui:133
i18n: ectx: property (whatsThis), widget (QSlider, delaySlider)
i18n: file: kcmmiscwidget.ui:161
i18n: ectx: property (whatsThis), widget (KIntNumInput, delay)
Hdyž so podpěruje, dowoli wam tuta opcija postajić, po kelko času stłóčena tasta tastowe kody generuje. 'Wospjetowanska rata' kontroluje frekwencu tutych tastowych kodow.
Translated by Eduard Werner
Located in rc.cpp:162 rc.cpp:165
6.
&Rate:
i18n: file: kcmmiscwidget.ui:177
i18n: ectx: property (text), widget (QLabel, lblRate)
&Rata:
Translated by Eduard Werner
Located in rc.cpp:171
7.
If supported, this option allows you to set the rate at which keycodes are generated while a key is pressed.
i18n: file: kcmmiscwidget.ui:187
i18n: ectx: property (whatsThis), widget (QSlider, rateSlider)
i18n: file: kcmmiscwidget.ui:215
i18n: ectx: property (whatsThis), widget (KDoubleNumInput, rate)
Tuta opcija, jeli steji k dispoziciji, dowoli Wam postajić, z kotrej frekwencu so tastowe kody generuja, doniž so tasta tłóči.
Translated by Eduard Werner
Located in rc.cpp:174 rc.cpp:177
8.
If supported, this option allows you to setup the state of NumLock after KDE startup.<p>You can configure NumLock to be turned on or off, or configure KDE not to set NumLock state.
i18n: file: kcmmiscwidget.ui:17
i18n: ectx: property (whatsThis), widget (KButtonGroup, numlockGroupBox)
Tuta opcija, jeli steji k dispoziciji, dowoli Wam postajić, hač je 'Num' při startowanju zaswěćeny.<p>Móžeće postajić, hač ma 'Num' być zaswěćeny abo nic, abo móžeće prajić, zo KDE 'Num' tajki wostaji, kaž je.
Translated by Eduard Werner
Located in rc.cpp:132
9.
NumLock on KDE Startup
i18n: file: kcmmiscwidget.ui:20
i18n: ectx: property (title), widget (KButtonGroup, numlockGroupBox)
'Num' při startowanju KDE
Translated by Eduard Werner
Located in rc.cpp:135
10.
T&urn on
i18n: file: kcmmiscwidget.ui:32
i18n: ectx: property (text), widget (QRadioButton, RadioButton1)
i18n: file: kcmmiscwidget.ui:71
i18n: ectx: property (text), widget (QRadioButton, keyboardRepeatOnRadioButton)
Z&aswěćić
Translated by Eduard Werner
Located in rc.cpp:138 rc.cpp:150
110 of 14 results

This translation is managed by translation group ubuntu-translators.

You are not logged in. Please log in to work on translations.

Contributors to this translation: Eduard Werner.